ESP32-S3-DevKitC-1
BoardAlso known as: esp32-s3-devkitc-1-n32r8v, esp32-s3-devkitc1-n16r16, esp32-s3-devkitc1-n16r2, esp32-s3-devkitc1-n16r8, esp32-s3-devkitc1-n4r2, esp32-s3-devkitc1-n4r8, esp32-s3-devkitc1-n8r2, esp32-s3-devkitc1-n8r8
Specifications
Radiosinherited from ESP32-S3
- Wi-Fi
- Wi-Fi 4 · 2.4 GHz
- Bluetooth LE
- BLE 5
- Bluetooth Classic
- no
- 802.15.4
- no
USB
- Native USB
- yes
- Connector
- micro-usb
Board
- Form factor
- devkit
- Battery connector
- no
- Charging
- no
Display & extras
- Extras
- rgb-led
ESP32-S3-WROOM-1 dev board with two micro-USB ports (UART bridge + native USB OTG) and an addressable RGB LED.
Firmware for this board
Known good
- WLEDKnown goodweb flasher
Flash WLED
Known good esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.
Unverified
- ESP32 Bit PirateUnverified
Flash ESP32 Bit Pirate
Unverified esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.
- ESPHomeUnverifiedweb flasher
Flash ESPHome
Unverified esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.
- NerdMiner v2Unverified
Flash NerdMiner v2
Unverified esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.
- OpenMQTTGatewayUnverified
Flash OpenMQTTGateway
Unverified esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.
- RuViewUnverified
Flash RuView
Unverified esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.
other
- ESP-Claw For StickS3declared
Flash ESP-Claw For StickS3
declared esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.
- NucleoOsdeclared
Flash NucleoOs
declared esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.
Notes
- Two micro-USB: a UART-bridge port and the native ESP32-S3 full-speed USB OTG port
- Addressable RGB LED (GPIO38 on v1.1, GPIO48 on v1.0)
- Carries ESP32-S3-WROOM-1/-1U/-2; fixed here to esp32-s3-wroom-1
- Dimensions only in a separate Dimensions PDF (omitted)
- io.gpio_free=27 DERIVED, not quoted (SPEC-io-power.md §5.3). Header J1+J3 break out 36 pads total (quoted from the user guide pin tables: J1 = GPIO 3-18,46; J3 = GPIO 0-2,19-21,35-45,47,48). Subtracting esp32-s3's soc.reserved_pins that are exposed -- strapping {0,3,45,46} (4) and usb_flash_tied {19,20,35,36,37} (5) -- gives 36 - 4 - 5 = 27. Math not vendor-stated; verify before treating as exact.
Verify my board
Reads the connected chip over USB and checks it against what esp-atlas cites for ESP32-S3-DevKitC-1 — over Web Serial, no backend, nothing leaves your browser.
In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.
Serial monitor
Not connected.