Adafruit pyCamera S3 (MEMENTO)

Board
by Adafruitadafruit-pycamera-s3≈ medium (~$15–50)

Also known as: adafruit_camera_esp32s3

Verify my boardCompareEdit on GitHub

Specifications

Radiosinherited from ESP32-S3

Wi-Fi
Wi-Fi 4 · 2.4 GHz
Bluetooth LE
BLE 5
Bluetooth Classic
no
802.15.4
no

USB

Native USB
yes
Connector
usb-c

Board

Form factor
memento
Battery connector
yes
Charging
yes

Display & extras

Display
1.54in 240x240 Color TFT
Extras
cameramicaccelerometerstemma-qtsd-card
Built onAdafruit pyCamera S3 (MEMENTO) BoardESP32-S3 SoC

ESP32-S3 DIY camera board with an OV5640 sensor, 1.54in color TFT, analog mic, LIS3DH accelerometer, microSD, and STEMMA QT.

Firmware for this board

No firmware recipes yet — help add one.

Notes

  • ESP32-S3 camera board retailed as the Adafruit MEMENTO.
  • soc/flash/psram QUOTED: "ESP32-S3 module with 4 MB Flash, 2 MB PSRAM".
  • usb.connector=usb-c QUOTED: "USB Type C". usb.bridge/usb_serial omitted: the guide does not explicitly state native-USB flashing wording, so left uncited rather than assumed.
  • power QUOTED: "LiPoly battery charging support" and "Use a 3.7/4.2V 350mA or 420mA battery".
  • display QUOTED: "1.54" 240x240 Color TFT".
  • extras QUOTED: camera "OV5640 camera module with 72 degree view and auto-focus motor"; mic "Analog Microphone"; accelerometer "LIS3DH Accelerometer"; stemma-qt "I2C Stemma QT Port"; sd-card "MicroSD card slot".
  • dimensions_mm omitted: not stated in mm on the guide. io omitted: no explicit broken-out GPIO count.

Verify my board

Reads the connected chip over USB and checks it against what esp-atlas cites for Adafruit pyCamera S3 (MEMENTO) — over Web Serial, no backend, nothing leaves your browser.

In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.

Serial monitor

Not connected.