T-Display

Board
by LILYGOlilygo-t-display≈ medium (~$15–50)
Verify my boardCompareEdit on GitHub
Flash this board — 1 firmware option
T-Display board
Board
T-Display pinout
Pinout

Specifications

Radiosinherited from ESP32

Wi-Fi
Wi-Fi 4 · 2.4 GHz
Bluetooth LE
BLE 4.2
Bluetooth Classic
yes
802.15.4
no

USB

Native USB
no
Bridge chip
ch9102

Board

Form factor
t-display

Display & extras

Display
1.14in 135x240 ST7789 SPI IPS
Built onT-Display BoardESP32 SoC

Original ESP32 dev board with a 1.14in 135x240 ST7789 SPI IPS display and a CH9102 USB-serial bridge.

Firmware for this board

other

  • ESP32 Bit Piratedeclaredpentest
    Flash ESP32 Bit Pirateguided

    declared esp-atlas asserts this board↔firmware link at the shown trust tier — it does not guarantee your specific unit or the current firmware version. Flashing can erase keys/config and can brick the device. At your own risk.

Notes

  • 4 MB or 16 MB flash options (board-level default/most-common SKU not confirmed in vendor docs, so flash_mb is left unset)
  • Onboard battery power detection circuit
  • Wi-Fi 802.11 b/g/n, Bluetooth v4.2+BLE
  • LilyGO's official Arduino IDE setup guide instructs users to select "Disable" for PSRAM, confirming this board has none
  • io OMITTED: the official README's "Pinout" table only lists pins consumed by the onboard ST7789 display/I2C/buttons/battery ADC (TFT_MOSI=19, TFT_SCLK=18, TFT_CS=5, TFT_DC=16, TFT_RST=23, TFT_BL=4, I2C_SDA=21, I2C_SCL=22, ADC_IN=34, BUTTON1=35, BUTTON2=0, ADC Power=14); it states no total exposed-pad count and no full side-header pin list, and no other official LilyGo page/schematic-checklist source was found with one, so gpio_exposed/gpio_free are left unset per cite-or-omit
  • usb_serial derived from usb.bridge (ch9102)

Verify my board

Reads the connected chip over USB and checks it against what esp-atlas cites for T-Display — over Web Serial, no backend, nothing leaves your browser.

In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.

Serial monitor

Not connected.