ESP32-WROVER

Board
by Freenovefreenove-esp32-wrover

Also known as: freenove_esp32_wrover

ESP32-WROVER pinout
Pinout

Specifications

Radiosinherited from ESP32

Wi-Fi
Wi-Fi 4 · 2.4 GHz
Bluetooth LE
BLE 4.2
Bluetooth Classic
yes
802.15.4
no

USB

Native USB
no
Bridge chip
ch340
Built onESP32-WROVER BoardESP32 SoC

Freenove's ESP32 development board built on the PCB-antenna ESP32-WROVER module, with a CH340 USB-to-serial bridge for flashing and a camera interface. It is the board inside Freenove's ESP32-WROVER starter kits.

Firmware for this board

No firmware recipes yet — help add one.

Notes

  • The board shipped in Freenove's ESP32-WROVER kits (FNK0060). Freenove's Preface says "the ESP32-WROVER is designed based on the PCB on-board antenna-packaged ESP32-WROVER module" and "ESP32 uses CH340 to download codes"
  • Onboard resources per the Preface: GPIO pins, LED indicator, camera interface, reset button and boot mode selection button, USB port
  • Two board revisions exist; Freenove says "The version on the left is no longer mass-produced, and we mainly maintain the version on the right"
  • The exact WROVER module variant, flash, PSRAM, USB connector type and dimensions are not stated in Freenove's text (omitted)
  • aka "freenove_esp32_wrover" is the board id in the pioarduino PlatformIO platform
  • Not the Freenove ESP32-WROOM board (FNK0090) or the Freenove ESP32-S3-WROOM board, which are separate products

Verify my board

Reads the connected chip over USB and checks it against what esp-atlas cites for ESP32-WROVER — over Web Serial, no backend, nothing leaves your browser.

In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.

Serial monitor

Not connected.