ESP-WROVER-KIT

Board
by Espressifesp-wrover-kit≈ medium (~$15–50)
Verify my boardCompareEdit on GitHub
ESP-WROVER-KIT board
Board

Specifications

Radiosinherited from ESP32

Wi-Fi
Wi-Fi 4 · 2.4 GHz
Bluetooth LE
BLE 4.2
Bluetooth Classic
yes
802.15.4
no

USB

Native USB
no
Connector
micro-usb
Bridge chip
ft2232hl

Board

Form factor
devkit

Display & extras

Extras
rgb-led
Built onESP-WROVER-KIT BoardESP32 SoC

ESP32-WROVER-E development/debug board with a built-in FT2232HL JTAG debugger and an onboard RGB LED.

Firmware for this board

No firmware recipes yet — help add one.

Notes

  • USB 2.0 A-to-Micro-B cable; FT2232HL provides both the UART bridge and on-board JTAG debugging
  • Carries an ESP32-WROVER-E module with 64-Mbit (8 MB) PSRAM
  • Four diagnostic red LEDs on FT2232HL GPIOs, plus a red 5V Power-On LED and an RGB LED (GPIO0/GPIO2/GPIO4)
  • Dimensions not provided in the user guide (omitted)
  • io.gpio_free=13 DERIVED, not quoted (SPEC-io-power.md §5.3). Main I/O connector JP1 lists 24 pads in its table, but the user guide states "GPIO16 and GPIO17 ... are not broken out to the board's pin headers" (reserved for PSRAM CS/CLK on the WROVER module) -- excluding those 2 leaves 22 usable exposed pads (GPIO 0,2,4,5,12-15,18,19,21-23,25-27,32-36,39). Subtracting esp32's soc.reserved_pins that are exposed -- strapping {0,2,5,12,15} (5) and input_only {34,35,36,39} (4); usb_flash_tied {6-11} none exposed -- gives 22 - 5 - 4 = 13. Math not vendor-stated; verify before treating as exact.

Verify my board

Reads the connected chip over USB and checks it against what esp-atlas cites for ESP-WROVER-KIT — over Web Serial, no backend, nothing leaves your browser.

In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.

Serial monitor

Not connected.