Adafruit QT Py ESP32 Pico
BoardAlso known as: adafruit_qtpy_esp32_pico
Specifications
Radiosinherited from ESP32
- Wi-Fi
- Wi-Fi 4 · 2.4 GHz
- Bluetooth LE
- BLE 4.2
- Bluetooth Classic
- yes
- 802.15.4
- no
USB
- Native USB
- no
- Connector
- usb-c
- Bridge chip
- cp2102n-or-ch9102f
Board
- Form factor
- qt-py
- Battery connector
- yes
- Charging
- no
Display & extras
- Extras
- rgb-ledstemma-qt
QT Py-form ESP32 PICO-D4 board with USB-C, STEMMA QT, RGB NeoPixel, and 8 MB flash / 2 MB PSRAM.
Firmware for this board
No firmware recipes yet — help add one.
Notes
- 8 MB flash, 2 MB PSRAM on the ESP32 PICO-D4 module
- flash_mb=8 QUOTED: guide states "8 MB of Flash memory". psram_mb=2 QUOTED: guide states "2 MB of PSRAM".
- Battery input pads on underside with diode protection for external packs up to 6V; no onboard charging. QUOTED: "Battery input pads on underside with diode protection for external battery packs up to 6V input".
- usb.bridge/usb_serial: this plain-ESP32 board has no native USB, so it flashes over a USB-serial bridge; the pinouts page documents two production variants -- QUOTED "The CH9102F USB to serial converter can handle 50bps to 4Mbps max rate." and "The CP2102N USB to serial converter can handle 3 mbps max rate." Because the fitted chip varies by run, usb_serial is recorded as usb-uart-bridge-unspecified.
- io.gpio_exposed=11 QUOTED: pinouts page states "There are eleven GPIO pins broken out to pads." (gpio_free omitted -- no vendor-printed free count and not derived here).
- extras QUOTED: "Built-in RGB NeoPixel LED with power control" and "STEMMA QT plug-n-play connector".
Verify my board
Reads the connected chip over USB and checks it against what esp-atlas cites for Adafruit QT Py ESP32 Pico — over Web Serial, no backend, nothing leaves your browser.
In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.
Serial monitor
Not connected.
