ESP32-Ethernet-Kit

Board
by Espressifesp32-ethernet-kit
Verify my boardCompareEdit on GitHub
ESP32-Ethernet-Kit board
Board

Specifications

Radiosinherited from ESP32

Wi-Fi
Wi-Fi 4 · 2.4 GHz
Bluetooth LE
BLE 4.2
Bluetooth Classic
yes
802.15.4
no

USB

Native USB
no
Connector
micro-usb
Bridge chip
ft2232h

Board

Form factor
devkit

Display & extras

Extras
ethernetrj45poe-addon
Built onESP32-Ethernet-Kit BoardESP32-WROVER-E ModuleESP32 SoC

ESP32-WROVER-E devkit that bridges Wi-Fi/BLE to wired Ethernet via an onboard IP101GRI PHY and RJ45 jack, with an FT2232H USB-JTAG/UART bridge and an optional Power-over-Ethernet add-on board.

Firmware for this board

No firmware recipes yet — help add one.

Notes

  • Board version documented: v1.2
  • Two-board kit: the Ethernet board (A) carries the ESP32-WROVER-E module and an IP101GRI 10/100 Ethernet PHY (RMII) and can run standalone; an optional PoE board (B, IEEE 802.3at, 5 V/1.4 A output) powers board A over the Ethernet cable
  • FT2232H provides a USB-to-JTAG channel (channel A) and a USB-to-serial channel (channel B) over a single Micro-USB port
  • Onboard Ethernet Link/Activity LEDs, a 4-bit DIP function switch, and BOOT/EN buttons
  • GPIO16/GPIO17 are not broken out because they are used internally by the ESP32-WROVER-E module's PSRAM
  • Flash/PSRAM inherited from the ESP32-WROVER-E module record, not restated here

Verify my board

Reads the connected chip over USB and checks it against what esp-atlas cites for ESP32-Ethernet-Kit — over Web Serial, no backend, nothing leaves your browser.

In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.

Serial monitor

Not connected.