ESP32-S2-DevKitM-1

Board
by Espressifesp32-s2-devkitm-1

Also known as: ESP32-S2-DevKitM-1-N4R2, ESP32-S2-DevKitM-1R

ESP32-S2-DevKitM-1 board
Board
ESP32-S2-DevKitM-1 pinout
Pinout

Specifications

Radiosinherited from ESP32-S2

Wi-Fi
Wi-Fi 4 · 2.4 GHz
Bluetooth LE
none
802.15.4
no

USB

Native USB
yes
Connector
micro-usb
Bridge chip
cp2102n

Board

Form factor
devkit
Dimensions
54 × 25.4 mm

Display & extras

Extras
rgb-led
Built onESP32-S2-DevKitM-1 BoardESP32-S2 SoC

Small ESP32-S2-MINI module board with a micro-USB CP2102N UART bridge and a GPIO18 addressable RGB LED.

Firmware for this board

No firmware recipes yet — help add one.

Notes

  • Single micro-USB port (power and communication via the on-board USB-to-UART bridge); the schematic names the bridge CP2102N-A02-GQFN28
  • Ordering variants with the PCB antenna: ESP32-S2-DevKitM-1-N4R2 (ESP32-S2-MINI-2, 4 MB flash, 2 MB PSRAM, recommended), ESP32-S2-DevKitM-1 (EOL, ESP32-S2-MINI-1, 4 MB flash, no PSRAM) and ESP32-S2-DevKitM-1R (EOL, ESP32-S2-MINI-1, 4 MB flash, 2 MB PSRAM); psram_mb omitted since it varies by SKU
  • The ESP32-S2-DevKitM-1U / -1U-N4R2 / -1RU variants carry an external antenna connector and are separate SKUs (not this record)
  • Addressable RGB LED on GPIO18
  • Dimensions 54.00 x 25.40 mm board outline, from the ESP32-S2-DevKitM-1 V1 Dimensions PDF
  • io.gpio_free=31 DERIVED, not quoted (SPEC-io-power.md §5.3). Headers J1+J3 break out 37 pads total (quoted from the user guide pin tables: J1 = GPIO 0-17; J3 = GPIO 18-21,26,33-46). Subtracting esp32-s2's soc.reserved_pins that are exposed -- strapping {0,45,46} (GPIO46 also listed under input_only, so counted once) and usb_flash_tied {19,20} -- 5 unique reserved pins, and GPIO26, which the ESP32-S2-MINI-2 datasheet says "is used by the embedded PSRAM on the ESP32-S2-MINI-2-N4R2 ... and cannot be used for other purposes" (the user guide lists header pin 26 as SPICS1) -- gives 37 - 5 - 1 = 31 on the recommended N4R2. On the EOL no-PSRAM ESP32-S2-DevKitM-1, GPIO26 is free (32). GPIO18 (RGB LED) is not subtracted. Math not vendor-stated; verify before treating as exact.

Verify my board

Reads the connected chip over USB and checks it against what esp-atlas cites for ESP32-S2-DevKitM-1 — over Web Serial, no backend, nothing leaves your browser.

In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.

Serial monitor

Not connected.