Adafruit ESP32-S2 TFT Feather (4MB Flash 2MB PSRAM)
BoardAlso known as: ADAFRUIT_FEATHER_ESP32S2_TFT
Specifications
Radiosinherited from ESP32-S2
- Wi-Fi
- Wi-Fi 4 · 2.4 GHz
- Bluetooth LE
- none
- 802.15.4
- no
USB
- Native USB
- yes
- Connector
- usb-c
- Bridge chip
- none — SoC native USB
Board
- Form factor
- feather
- Battery connector
- yes
- Charging
- yes
Display & extras
- Display
- 1.14in 240x135 IPS ST7789
- Extras
- rgb-ledstemma-qt
Feather-form ESP32-S2 board with a front-mounted 1.14in 240x135 IPS display, native USB-C, LiPoly charging, NeoPixel, and STEMMA QT.
Firmware for this board
No firmware recipes yet — help add one.
Notes
- 4 MB flash, 2 MB PSRAM
- Front-mounted color 1.14" IPS TFT, 240x135 pixels, ST7789 chipset (vendor: "bright and colorful display with ST7789 chipset that can be viewed at any angle")
- LiPoly battery with built-in USB-C charging; LC709203 I2C battery monitor
- NeoPixel with pin-controlled power; STEMMA QT connector with switchable power; Reset and DFU (BOOT0) buttons; On/Charge/User LEDs
- io.power_out QUOTED: vendor pinouts page states "These pins are the output from the 3.3V regulator, they can supply 500mA peak."
- usb_serial OMITTED: soc esp32-s2 usb.type is otg-full-speed with no serial-JTAG peripheral, so there is no native-usb-serial-jtag path (matches sibling adafruit-feather-esp32-s2)
- dimensions_mm OMITTED: no board dimensions stated on the vendor overview or pinouts pages
- io.gpio_exposed/gpio_free OMITTED: vendor pinouts page does not print an explicit broken-out GPIO count, so no count is derived
Verify my board
Reads the connected chip over USB and checks it against what esp-atlas cites for Adafruit ESP32-S2 TFT Feather (4MB Flash 2MB PSRAM) — over Web Serial, no backend, nothing leaves your browser.
In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.
Serial monitor
Not connected.
