Adafruit ESP32-C6 Feather
BoardAlso known as: ADAFRUIT_FEATHER_ESP32C6
Specifications
Radiosinherited from ESP32-C6
- Wi-Fi
- Wi-Fi 6 · 2.4 GHz
- Bluetooth LE
- BLE 5.3
- Bluetooth Classic
- no
- 802.15.4
- Zigbee 3.0, Thread 1.3, Matter
USB
- Native USB
- yes
- Connector
- usb-c
- Bridge chip
- none — SoC native USB
Board
- Form factor
- feather
- Battery connector
- yes
- Charging
- yes
Display & extras
- Extras
- rgb-ledstemma-qt
Feather-form ESP32-C6 board (Wi-Fi 6 / BLE 5 / 802.15.4): USB-C with native USB Serial/JTAG, LiPoly JST charging with MAX17048 monitor, NeoPixel, and STEMMA QT.
Firmware for this board
No firmware recipes yet — help add one.
Notes
- 4 MB flash (vendor overview: "4MB of flash")
- psram_mb OMITTED: the vendor page lists flash but does not state any PSRAM, so no value is recorded (absence is neutral, not asserted as zero)
- LiPoly charging and monitoring with the MAX17048; STEMMA QT I2C port; status NeoPixel; second low-quiescent LDO (vendor cites as low as 17uA deep sleep)
- io.power_out QUOTED: vendor pinouts page states "These pins are the output from the 3.3V regulator, they can supply 500mA peak."
- usb_serial derived from usb.bridge (native) + soc usb.type serial-jtag: the ESP32-C6 flashes over its built-in USB Serial/JTAG core, not a UART bridge. Vendor overview: "built in USB Serial core" for debugging only, "cannot run UF2" and cannot act as an HID or mass-storage device
- dimensions_mm OMITTED: no board dimensions stated on the vendor overview or pinouts pages
- io.gpio_exposed/gpio_free OMITTED: vendor pinouts page does not print an explicit broken-out GPIO count, so no count is derived
Verify my board
Reads the connected chip over USB and checks it against what esp-atlas cites for Adafruit ESP32-C6 Feather — over Web Serial, no backend, nothing leaves your browser.
In-browser verify needs Web Serial: Chrome or Edge on a desktop. Safari, Firefox and phones cannot do it.
Serial monitor
Not connected.
